ElectraGlaze: unique, highly wear resistant, ESD (static control) floor finish specially formulated for use on all ESD conductive vinyl's, non conductive VCT and standard vinyl.
Unlike typical static control wax, our new innovative formulation features an incredibly tough, highly abrasion resistant, metal cross linked acrylic blend that actually improves the reduction of tribocharging without significantly altering the electrical resistivity of your esd flooring.
ElectraGlaze / ElectraGlaze Ultimate / UltraGlaze
Material Safety Data Sheet
SECTION I - IDENTITY
United Static Control Products Inc
4878 Lakeview Circle
Colorado City, CO 81019
United States of America
Trade Names: ElectraGlaze / ElectraGlaze Ultimate / UltraGlaze
Hazardous - NO
4 = Most Hazardous
Health - 1
Flammability - 0
Reactivity - 0
Personal Protection - B
Telephone Number for Information: (719) 676-3928
Emergency Phone Number: 1-719 676 3928 or Poison Center
Date Prepared: 05/12/05
Prepared by: T Copper
SECTION II - HAZARDOUS INGREDIENTS
Hazardous Components Weight% PEL (TWA) STEL CAS Number
Ingredient: Ammonium Hydroxide <1% 50ppm 35PPM 1336-21-6
CONTAINS: GLYCOL ETHER DM** <10% ne* ne* ne*
* Not Established
**CHEMICAL CATEGORY SUBJECT TO REPORTING REQUIREMENTS OF SEC.313, TITLE III
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling point: 212F
Specific Gravity (Water=1): Variable
Vapor Density (water vapor=1): 1
Evaporation Rate (water=1): 1
Solubility in water: Complete
pH: 7.0 to 9.5
Appearance and Odor: Translucent with mild odor
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point: Greater than 250 deg F
Auto Ignition: Greater than 250 deg F
Extinguishing Media: C02, ,Dry Chemical
Special Fire fighting procedures: Toxic gases may be release
use self contained breathing apparatus).
Unusual explosion hazards: None
SECTION V - REACTIVITY DATA
Conditions to Avoid: Freezing, temperatures over 212 deg F (will boil away water)
Incompatibility: treat as water
Hazardous Decomposition or Byproduct: may produce toxic gases
Hazardous Polymerization: Will not occur
SECTION VI - HEALTH HAZARD DATA
Inhalation: Prolonged exposure may produce headaches and mucous membrane irritation
Skin contact: May cause skin irritation
Eye contact: May cause irritation
NTP - NA IARC Monographs - NA OSHA Regulated - NO
Signs and Symptoms of Exposure: Irritating sensation, Ingestion; Nausea may occur
Emergency and First Aid Procedures:
Skin - Wash contact areas with soap and water, remove contaminated clothing and shoes
Ingestion - Induce vomiting if conscious, contact Physician.
Inhalation - Remove to fresh air call Physician if symptoms persist
Eye Contact - Flush eyes with copious amount of water, contact Physician.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
Steps to be Taken in Case Material is Released or Spilled:
Dike, collect material into watertight container, rinse surface with clean water.
Waste Disposal Method: Use sanitary landfill disposal, (not a hazardous
waste) according to federal, state and local regulations. (RCRA, Subtitle D.)
Precautions to be Taken in Handling and Storage - Do not mix with other
chemicals, store away from heat. KEEP FROM FREEZING.
Other Precautions - KEEP AWAY FROM CHILDREN
SECTION VIII - CONTROL MEASURES
Respiratory Protection - Not required in well ventilated areas.
An approved organic vapor full face respirator is advised in poorly ventilated areas
Ventilation - Local Exhaust - Non required
Mechanical - NA
Special - NA
Other - Assure fresh air circulation
Protective Gloves - RECOMMENDED: Rubber, Plastic
Eye Protection - RECOMMENDED: Safety glasses
Other Protection - NA
Work/Hygienic Practices - Do not eat or drink next to material, wash hands after work.
SECTION IX - TRANSPORTATION 49 CFR
Unit Cont. - 55,30,5,1 GAL. PLASTIC CONT Report Qty. (Lbs) - NA.
OSHA - NOT REGULATED. Labels - NO.
DOT - NOT REGULATED.
UN - NOT REGULATED.
Vendor assumes no responsibility for injury to vendee or third person proximity
caused if reasonable safety procedures are not adhered to as stipulated
in the data sheet. Additionally, vendor assumes no responsibility for injury
to vendee or third persons proximately caused by abnormal use of the material
even if reasonable safety procedures are followed. Further more, vendee
assumes the risk in use of the material.