STATIC CONTROL FLOORING OPTIONS

ElectraGlaze Static Control Floor Finish

Protect and Enhance the Performance of your Static Control  Floors

ElectraGlaze                    ElectraStrip                    ElectraClean

ElectraGlaze and our refined system of static control floor care products = Ultimate Performance, Conductivity and Longevity. ElectraGlaze Shine and Scuff removal?  Unparallel to ANY product on the Market. We’ve distributed ESD Floor Chemicals since '93, evaluated the best and (if asked) can tell you the good the bad and the UGLY about all of them!  If you're like most of our clients you've grown weary of seeing your resistance values raise to the point that you're hoping for a rainy day to bring them down!

NO MORE WISHFUL THINKING OR PRAYING FOR RAIN!

ElectraGlaze, wear resistant, extremely cost effective static control wax (floor finish) for use in ESD sensitive environments.  Unlike typical static control wax, our new proprietary formulation features a proprietary, aqueous co-polymer blend. This exclusive blend provides dramatically superior chemical, water and slip resistance with the best resistance to abrasions and scuffmarks in the industry.  In addition, ElectraGlaze provides extremely reliable electrical conductivity. Applications are quick and simple, requiring only two coats (on esd floors) that dry in 60 minutes (depending on your environment). It never requires buffing but has the flexibility to be polished (if desired) to an incredible luster.

Low Odor, NO VOC's and Biodegradable. Exceptional electrical conductivity

Application:
This material is for use on conductive ESD vinyl, epoxy and standard flooring. If the floor has been previously coated with a wax or "factory applied finish" (as is the case with standard VCT, OR if floor is extremely dirty, remove contaminants with emulsifying floor stripper such as ElectraStrip Floor Stripping Liquid. Neutralize with 1 ounce of ElectraClean mixed with 1 gallon of clean cool water. Allow to dry thoroughly.  Using a new clean Rayon mop or wax applicator, apply 2 thin even coats of ElectraGlaze allowing finish to dry 2 hours between coats.  Two  coats are recommended for optimum performance. Buffing is not required between coats unless high luster is desired  For complete instructions on utilizing United's ESD Floor Maintenance Solution please visit: http://ultrastatinc.com/floor_chems.html

Maintenance:  Dry mop floors with a untreated mop daily to remove loose dirt, sand and other abrasives.  Damp mop as needed to remove soils which can degrade the coatings conductive properties and gloss.

Product Data:

% solids: >20%, ASTM D2834-34

pH: 7.25, ASTM E70-77

Gloss: 88 min, ASTM D1455-82

Recoatability: Excellent, ASTM D3153-78

Rubber Heel Marks: 1.0, ASTM  D1436-82/

Resistance: Excellent CSMA # 9-73

Powdering Resistance: Excellent, ASTM D2048-82

Freeze / Thaw Stability: Passes 3 Cycles, ASTM D3209-82

Static coefficient of friction: >0.55, ASTM D2047-82

Slip Resistance per NFSI test method 101-A: 0.7 Neolite, 0.8 rubber

Shelf Life: 18 months min,

Flash Point: none

Electrostatic Decay Time EIA 541: <0.1 sec

• Highly abrasion and scuff resistant
• Long lasting for reduced maintenance cost.
• High gloss, esthetically pleasing luster.
• Non flaking , Non slippery
• Low tribo-charge generation
• UL listed-Slip Resistant